HardDrive

HardDrive

The part has an interface to access the vessel hard drive, where the science data files are stored. Only one HardDrive module can be defined per part.

PROPERTY	DESCRIPTION	DEFAULT
dataCapacity	Base storage capacity for data, in Mb (=Mib)	-1
	-1 = unlimited.
sampleCapacity	Base capacity for experiment samples, in slots (=Mib).	-1
	Note that Kerbalism will not display sample sizes in Mb,
	but uses a virtual size unit instead (slots, bags) (TBD)
	-1 = unlimited.
experiment_id	If set, restricts write access to the experiment with that
	id ON THE SAME PART with the given experiment_id.
maxDataCapacityFactor	number of capacity increments available in the editor	4
dataCapacityCost	cost factor for added data capacity	400.0
dataCapacityMass	mass factor for added data capacity	0.005
maxSampleCapacityFactor	number of capacity increments available in the editor	4
sampleCapacityCost	cost factor for added sample capacity	300.0
sampleCapacityMass	mass factor for added sample capacity	0.008

If the capacities are >0, you can set up to maxDataCapacityFactor or maxSampleCapacityFactor times the base capacity in the editor.

dataCapacityCost, dataCapacityMass, sampleCapacityCost and sampleCapacityMass are only effective for additional capacity only. The base dataCapacity / sampleCapacity is free, any additional capacity is multiplied with that value. A hard drive with 3 times the base capacity adds 3 times the cost factor to the part costs.